Step 4: Now, I will drag my cursor in the right direction and give the length of 60 mm – press Enter key. Step 3: Turn Ortho On for a straight line. I will show it to you by creating a Rectangle by using the line command. Give another direction, then again give length, and press Enter key. Step 3: Give direction in which you want to draw a line, give length, then press Enter key.
Step 1: For creating an object, take a line command. You can easily make an object my use line command after learning the line command thoroughly. The further examples illustrate on creating an object by line command. You can continue your line as many as the time you want. Step 6: Give inclination angle 150, then press Enter to apply this command. Step 5: I will show you how to continue your line. If you want to continue the line in other direction and inclination, then don’t exit from line command just again give the length of line and inclination angle by following the same steps as we did previously. Step 4: Press tab to give the angle of inclination and type 30 as angle, then press Enter to apply the command, and again press Enter to exit. Step 2: I will make sure that my Ortho is in Ortho off mode. Step 1: Give the first point in my workspace. Step 6: Again, press Enter or Esc to leave the command. Step 5: Press the tab and give the inclination angle, and press Enter key. Step 3: Make sure Ortho is in ‘Ortho off’ mode for putting it off, press the F8 key. For drawing an inclined line, take a line command from the draw tool. You can easily draw it by giving the inclination angle. Let’s understand this method with a few examples: Example #1ĭrawing an inclined line in AutoCAD is not hard work. Snapping makes drawing easy in AutoCAD software. center point of the line, endpoint of the line, etc. These dots are snapping points of that line or object, i.e. The selection will show in blue color with some dots. Step 7: You can select any line or object by clicking on it. Step 6: Now, I will drag the mouse in the right direction and give the length of 40 mm by typing it from the keyboard and will click Ok to apply my command and press Enter to exit. Step 5: Take the point anywhere in the workspace, turn Ortho On by pressing the F8 key. Step 4: Here, I will show it by example I will take the line command from the draw tool. To exit any command, just press Enter or Esc button on the keyboard. Step 3: Give the direction, give length, then click OK or simply press Enter from the keyboard. Step 2: Turn Ortho On for creating your line straight for turning Ortho On, you can press F8 or click on Ortho On option as shown in the below image.
0 kommentar(er)
